West Sussex · Fire damper testing
Fire Damper Testing in Newpound Common
Fire damper testing for Newpound Common and the surrounding area: diagnosis first, then a fixed quote, the work and a report with photos. Call for a fixed quote.
- Rusted damper blades and springs
- Fire dampers nobody can get to
- Fire damper items raised by an assessor
When something else is needed
A few issues sit outside what this work can do:
- Fire risk assessments, which need a fire risk assessor
- Dampers that were never installed where they’re needed
- Fire-stopping gaps around the duct where it passes through the wall
If in doubt, call 0345 646 2711 or send us an email and we’ll say what we think before booking.
What we work on in Newpound Common
- Fusible link fire dampers
- Wall and floor dampers
- Riser dampers
- Hospitals and care homes
- Offices and schools
- Motorised smoke dampers
How we handle fire damper testing in Newpound Common
In a fire, ductwork can act as a shortcut for flame and smoke from one part of a building to the next. A damper only does its job if the blade can drop fully. Annual drop testing is how you know in each part of the building. If you have dirty dampers that may not close and motorised smoke dampers due for testing, we can put it right.
In rural areas, conversions, country hotels and care homes can have ductwork crossing fire-resisting walls, where the dampers are easy to overlook. The first visit starts by locating each damper.
Think of the report as the system’s health record: dated, with photos, and showing what was done. For TR19® Grease cleans, the certificate comes through the BESCA Vent Hygiene Elite portal and sits alongside the report.
- Place
- Newpound Common (RH14)
- Region
- West Sussex
- Reporting
- Written report with photos
- Price
- Fixed quote, normally within a working day
- Working hours
- When your site is closed, plus a 24/7 line
- Telephone
- 0345 646 2711
- Last updated
- 30 October 2026
Fire damper testing in Newpound Common: local notes
Newpound Common sits within the area of West Sussex Fire and Rescue Service. In most workplaces and other non-domestic buildings, it’s the fire and rescue authority that enforces the Fire Safety Order. Newpound Common is about 37 miles from central London, well within the area we cover across London and the South East. We work evenings, overnight and at weekends, so the visit fits around the site.
A school like Wisborough Green Primary School can have any dampers tested over half-term without disturbing lessons.
Newpound Common is about 8 miles west of Horsham, in West Sussex. Sites in Newpound Common get the same service as everywhere we cover: diagnosis first, a fixed price, out-of-hours working where necessary and a written report with pictures. Newpound Common is one of 371 towns, villages and districts in West Sussex we cover for fire damper testing. There’s also a page for Guildford, roughly 15 miles from Newpound Common.
Our technicians cover all of RH14 for fire damper testing and the streets around it. That includes premises on Newpound and Newpound Lane and the roads around them. Close by, we work in Billingshurst (2 miles south-east), Five Oaks (3 miles east), The Haven (3 miles north-east), Coneyhurst (3 miles south-east) and Tisman's Common (4 miles north). Within a short drive, we also cover Crawley (14 miles north-east), Horsham (8 miles east), Worthing (15 miles south), Littlehampton (15 miles south), Rustington (15 miles south) and Broadfield (13 miles east).
Landmarks near Newpound Common
Around Newpound Common, our work takes us to kitchens and buildings near The Cricketers Arms Public House and The Weald School, among other places. Newpound Common’s nearest station is Billingshurst station, roughly 2.1 miles south-east of the centre. The countryside around Newpound Common includes The Mens.
Also near Newpound Common
What else we do in Newpound Common
When to call us in Newpound Common
Corrosion is another common cause of failure. Condensation, leaks and damp plant rooms corrode the parts that need to move, so a damper can seize without anyone noticing.
Most sites get in touch after spotting one of these:
- Dust or grease build-up on damper blades
- Smoke dampers with no recent test
- Dampers flagged on a fire risk assessment
- Missing or out-of-date damper records
In Newpound Common, each damper is dropped to prove it closes fully, then reset.
What to look for in a quote
- Whether inaccessible sections are listed on the report
- Proof of accreditation you can verify
- What insurance they carry
- Whether the price is fixed
How it works
We’re used to working while the site is closed. A lot of visits happen overnight or at weekends, so the site can open as normal afterwards. The visit itself takes anything from a couple of hours for a handful of dampers to a full day for a large building. Pictures of the system and its access let us plan the work in Newpound Common before we set off.
- First we look at any damper register, drawings or earlier test reports.
- Dampers are located one by one and reached through their access panels.
- Every fire damper is dropped, and every smoke damper is tested through its controls.
- We reset every damper that passes and check it’s left open.
- We report on every damper, with faults and suggested remedials set out.
Preparing for the visit
- Arrange a key holder or contact on site
- Dig out any earlier paperwork for the system
- Tell us about access, such as roof hatches, plant rooms, ceilings or locked areas
Getting a quote
Quoting starts with a diagnosis, from your photos and details or, where that isn’t enough, a survey on site. Then we send a fixed price so you know the cost before we start.
Advice
Landlords, agents and facilities managers
Keeping records across a portfolio is half the battle. Each visit produces a dated report with photos, ready to show insurers, fire officers or EHOs.
Running several sites is easier with one contractor. We work across London and the South East, so visits at different addresses can be planned together and kept to a regular schedule.
What staff can safely do
Staff cleaning does not replace a specialist visit; it supports it. Clean filters and tidy surfaces slow the build-up, but hidden parts of the system still need specialist attention.
Staff cleaning and specialist work are not the same thing. A daily filter wipe and a weekly filter wash keep grease down at the front of the system, but grease that has passed the filters is out of reach. That part needs specialist access and equipment.
What affects the cost of fire damper testing
The diagnosis comes before the price. We look at:
- A single visit or a regular plan
- What state the system is in
- Where the site is and how we reach it
- Any permits to work or inductions
The price reflects the work, not guesswork. That’s why every job is surveyed first, and the price is agreed before work begins.
What we need to know
There’s no need for technical detail. It helps if you can send:
- How we’d reach plant on a roof or in a plant room
- The postcode and the type of business
- Your opening hours and when the area is out of use
- Any previous report or certificate
To get a fixed quote, give us a ring on 0345 646 2711, or send details by email with the site type, your trading hours and a short description of the system. A few pictures and your last certificate or report help a lot. You will typically have a quote within one working day.
Questions from Newpound Common
Can you get to a site in Newpound Common?
Yes. Newpound Common is within the area we cover across London and the South East. Photos of the system and directions to the site help us plan the visit.
Can fire dampers in schools around Newpound Common be tested in the holidays?
Yes, out-of-term visits are normal for schools. There are about 2 schools, colleges and universities on the FSA’s food hygiene register within about 1.5 miles of Newpound Common. Just call us on 0345 646 2711 or use the quote form with your term dates and we will plan around them.
What is TR19?
A BESA specification, with two parts that matter most here: TR19® Grease for kitchen extract systems and TR19® Air for general ventilation. It is not legislation, but it’s the standard people check against.
What if a fire damper won’t close?
We record the damper as failed, with the reason, such as a sticking blade, corrosion or a damaged link. We offer remedials to repair or replace it, and test it again afterwards.
Are you accredited?
We hold CHAS, SafeContractor and ISO 9001, and we are a BESCA Vent Hygiene Elite member, cleaning to BESA TR19® Grease. The Vent Hygiene Elite scheme is run by BESCA and audited independently.
Are you fully insured?
Yes. Full insurance covers our work, and we’ve been trading since 2009.
Does the law say we must follow TR19?
No, not in itself. TR19® is the benchmark insurers, fire officers and EHOs check against, and many insurance policies ask for proof of TR19® cleaning. The law behind it is the Fire Safety Order 2005 in England and Wales.
Do we need to close while you work?
Not usually. Out-of-hours visits keep the disruption down. Bigger sites can be done in stages so parts stay in use.
Aftercare tips
Looking after the system between visits is straightforward, and it helps at the next visit:
- Store test records alongside the fire risk assessment
- Update the register when ductwork changes
- Keep cables and fixings away from damper blades
- Book the next test before the year runs out
Dampers we couldn’t reach are listed with the reason, for example a missing panel or a covered hatch. Access panels can be fitted so those dampers are tested on the next visit.
A simple register of every damper helps a great deal: where each damper is, what kind it is and when it was last tested. It stops dampers getting lost as the building changes.