Essex · Extract fan repair and replacement
Fryerning extract fan repair
Looking for extract fan repair in Fryerning? We diagnose first, fix the price and book the work around your hours, then sign off with a report and photos.
- A fan worn beyond sensible repair
- A humming noise from the fan motor
- A squealing belt on start-up
Leave it or put it right?
An overloaded motor is under constant strain. Every hour of strain takes its toll and a burnt-out motor is a bigger job than a worn belt. Early attention keeps the cost and disruption down. A fault that closes a site in a village like Fryerning affects everyone who depends on it.
Working hours, access and the scale of the site can all change the price. Each of those is built into the quote, and the price is fixed before work begins.
Why choose Duct Doctor in Fryerning
- Photo reports with every job
- BESCA Vent Hygiene Elite member, cleaning to BESA TR19® Grease
- Out-of-hours work and a 24/7 emergency line
- Survey first, then a fixed quote
See our cost guide and how to check a contractor.
Extract fan repair for kitchens and businesses in Fryerning
A faulty fan does not always mean a new one. Often a clean, a new belt or new bearings brings it back, and that’s what we will recommend. Where the motor has burnt out or the unit is past saving, we fit a replacement matched to the duct and the kitchen. The work covers bearings, roof and wall fans and fan housings, and the jobs we see most are a dead fan motor and a fan worn beyond sensible repair.
Somewhere as small as Fryerning, a kitchen extract fan might serve a pub, a school, a care home or a hall kitchen. When one fails, the cooking stops, and our 24/7 emergency line covers rural addresses too.
Every visit ends with a written report and pictures, so you have a record of what was done and when. Kitchen extract cleaning to TR19® Grease is certificated through the BESCA Vent Hygiene Elite portal.
- Where
- Fryerning (CM4)
- Region
- Essex
- Paperwork
- Written report with photos
- Quote
- A fixed price before work begins
- Working hours
- Evenings, overnight and weekends; 24/7 emergencies
- Phone
- 0345 646 2711
- Page updated
- 30 October 2026
FAQs for Fryerning
Is there an emergency callout for extract fans in Fryerning?
We run a 24/7 emergency line for failed extract fans, and Fryerning is part of our area. Ring 0345 646 2711 at any hour and describe the fault. Tell us where the fan is and how to reach it.
Which council inspects kitchens in Fryerning?
The local authority for Fryerning is Brentwood council, and its environmental health team does the inspecting. Inspections are risk-based, so a visit can come at any time, including the week a fan stops.
Does the law say we must follow TR19?
No. TR19® itself isn’t law; it’s a BESA specification. The legal duty comes from the Regulatory Reform (Fire Safety) Order 2005: the responsible person must assess and reduce fire risk, and cleaning to TR19® is the recognised way to show grease is under control.
What about areas you cannot get to?
They’re listed in the report, never skipped quietly. You will know exactly which parts weren’t reached and why, along with a quote to put access in.
How much does an extract fan repair cost?
The cost depends on what’s wrong and how easy the fan is to reach. After diagnosing, you get a fixed quote before any work starts.
Does a fan repair include cleaning the ductwork?
Repairing the fan does not clean the canopy or ducts. If there’s grease on the fan, a full TR19® clean is worth booking and we can plan the two together.
Will you fit a new fan if ours cannot be repaired?
Yes. If repair isn’t sensible, we replace the fan. The replacement has to suit the ductwork and the cooking before recommending a unit.
Do we lose a day’s trading?
Not normally. The area we are working in has to be out of use while we are there, so the visit goes in a quiet slot.
What we do, step by step
Protection comes first: sheeting goes over floors and surfaces close to the work. Then we make the system safe and start. It takes an hour or two to diagnose, then longer if parts or a new fan are needed, and we clear up before we go. Somewhere like Fryerning, lanes, gates and parking are worth mentioning in advance.
- We agree a time to attend, out of hours if needed.
- The extract is switched off and the fan opened up.
- Bearings, drive, impeller, motor and mounts are inspected.
- We explain the options and quote a fixed price.
- The fan is repaired or replaced, then checked running.
Before we arrive
- Mention any locked doors, roof access or ceiling voids
- Mention any parking or loading restrictions
- Name a contact who can let us in at the agreed time
Getting a quote
To get a fixed quote, call 0345 646 2711 or use the quote form with the site type, your trading hours and a short description of the system. A few pictures and your last certificate or report help a lot. You’ll typically have a quote within one working day.
Related advice
Extract fans in Fryerning
There are about 7 restaurants, cafés and canteens within roughly a mile and a half of the centre of Fryerning, according to the Food Standards Agency’s register. Wherever they cook under a canopy, a failed extract fan stops the kitchen. Fryerning is about 24 miles from central London, well within the area we cover across London and the South East. We work evenings, overnight and at weekends, so the visit fits around the site. It’s Brentwood council that sends environmental health officers to food businesses in Fryerning. Food premises are expected to have suitable and sufficient ventilation under food hygiene rules. That makes a fan repair urgent rather than something to put off.
If you look after a church or hall kitchen near Church of St Mary the Virgin, or anywhere in Fryerning, test the extract fan before a big event rather than on the day. If you run a kitchen close to Ingatestone station and the extract fan is getting noisy, a planned repair after closing beats a breakdown at the rush.
Fryerning is about 4 miles north-west of Billericay, in Essex. Wherever you are in the CM4 postcode area, we can carry out extract fan repair at your premises. Fryerning is one of 644 places in Essex we cover for commercial clients. We also work in Chelmsford, around 6 miles away.
Work in CM4 is surveyed, quoted and booked the same way as anywhere else. Whether your site is on Back Lane, Mill Green Road and Mill Lane or anywhere close by, our technicians can take on the work. We also cover Mill Green (1 mile north), Ingatestone (1 mile south), Beggar Hill (1 mile north-west), Green Street (1 mile west) and Mountnessing (2 miles south-west). Within a short drive, we also cover Chelmsford (6 miles north-east), Basildon (8 miles south-east), Harlow (13 miles north-west), Brentwood (5 miles south-west), Maldon (14 miles east) and Canvey Island (14 miles south-east).
Local landmarks in Fryerning
Locally, jobs take us to businesses close to Anglo European School and The Cricketers pub. The nearest railway station is Ingatestone station, about 0.9 miles south-east of the centre. Other landmarks nearby include Mayflower Community Hospital (4.2 miles south). For a walk, there’s Norsey Wood.
What we are called out for in Fryerning
Some faults are in the controls rather than the fan. Speed controllers, isolators and wiring can all fail, and a fan that won’t start is not always a dead motor.
Signs it’s time to call us include:
- A fan that keeps cutting out
- A fan that whines, hums or grinds
- Weak extraction and a smoky kitchen
- An extract fan that has stopped working
If you manage a school such as Ingatestone Infant School and the kitchen fan is getting louder, the next break is the time to deal with it.
Questions to ask before booking
- What records you will receive afterwards
- Whether inaccessible sections are listed on the report
- How they set the interval to the next visit
- Their accreditations, such as BESCA Vent Hygiene Elite, CHAS or SafeContractor
When something else is needed
We’d rather tell you now than book work that will not help, so here are the limits:
- Wiring and supply faults beyond the fan itself
- An extract system that was undersized from the start
- Smells from the discharge that need odour control equipment
Not sure which it is? You can call 0345 646 2711 or email us and we will tell you honestly.
Parts of the system we cover
- Fan housings
- Fan motors
- Kitchen extract fans
- Belts and pulleys
- Roof and wall fans
- Bearings
Keeping the system healthy
To keep the system working properly between visits:
- Keep the emergency number where staff can see it
- Keep the grease filters clean and fitted
- Make sure the isolator and controls are easy to reach
- Keep the fan on a planned cleaning cycle
If the fan had grease on it, the rest of the system almost certainly does too. A full TR19® clean deals with the canopy, ductwork and fan together and you get a TR19 certificate and photo report afterwards.
A 3, 6 or 12-monthly cleaning plan brings us back at set intervals, so the fan is looked at as part of each visit and wear is caught earlier.
How the job changes from site to site
Fan controls
Where the fault is in the building’s electrical supply, an electrician is needed. We will tell you if that is what we find so you know who to call.
Impellers and housings
The impeller does the work of moving air through the system. Grease on it throws it out of balance and make it shake.
What staff can safely do
Your own staff can handle the daily basics: wiping canopies, washing grease filters and recording it in a log. Inside the ducts, risers and fan is specialist work, and that is where we come in.
In-house cleaning and specialist cleaning do different jobs. A daily filter wipe and a weekly filter wash keep grease down at the front of the system, but they don’t reach the grease that builds up further in. That part needs specialist access and equipment.