Isle of Wight · Ductwork cleaning
Skinner's Hill ductwork cleaning
Specialist ductwork cleaning for Skinner's Hill: diagnosis first, then a fixed quote, the work and a report with pictures. Call for a fixed quote.
- Thick deposits at the bottom of a vertical duct
- Duct runs with no cleaning record
- High readings at a recent grease test
Looking after it afterwards
Results last longer with the right care. Here’s what we suggest:
- Flag drips from the duct straight away
- Keep to the interval on the report
- Check readings when the menu changes
- Consider fitting panels where the report shows gaps
Grease readings are taken again at the same set points, giving you before and after readings. Photos of each section go alongside them.
Some signs mean the duct needs attention sooner: grease leaking from duct joints, smells, or a fan that sounds rough. A grease thickness test can confirm whether a spot clean is needed.
How we handle ductwork cleaning in Skinner's Hill
The ductwork is where an extract clean is won or lost. Sections with no way in can go uncleaned for years. Each section we can reach is cleaned, and any we can’t is written down, so you know exactly where you stand. The work covers multi-storey ducts, bends and junctions and attenuators, and common reasons people get in touch are years of grease along the duct floor and readings above 200 microns from a grease thickness test.
In a small place like Skinner's Hill, kitchens are often in older or extended buildings, with long single-storey duct runs, and those horizontal sections are where grease settles. Access, parking and timings are agreed before the day.
It’s worth checking any contractor’s accreditations. Ours are BESCA Vent Hygiene Elite membership, cleaning to BESA TR19® Grease, plus CHAS, SafeContractor and ISO 9001, and we’re fully insured.
- Location
- Skinner's Hill (PO36)
- Region
- Isle of Wight
- Paperwork
- Certificate plus before-and-after photos
- Quote
- A fixed price before work begins
- Hours
- Evenings, overnight and weekends; 24/7 emergencies
- Phone
- 0345 646 2711
- Reviewed
- 30 October 2026
What happens if it’s left?
BESA guidance says grease shouldn’t exceed a mean of 200 microns between cleans. A reading of 500 microns or more at any point means a spot clean right away. Putting off the clean only pushes readings higher. Planning a trip to Skinner's Hill ahead is easier for everyone than a rushed one.
Leaving it longer rarely makes the work cheaper. Build-up, wear and faults tend to get worse, not better, and a neglected system can mean more work. If you’re not sure what’s needed, call 0345 646 2711 or drop us a line for straight advice and a fixed quote.
Why book with us
- CHAS, SafeContractor and ISO 9001
- Work around your opening hours, with 24/7 emergency cover
- Trading since 2009
- Survey first, then a fixed quote
Read our cost guide and how to check a contractor.
What a clean will not put right
We won’t sell you work that doesn’t address the problem, so here are the limits:
- Sections that cannot be reached safely without new access (those are recorded, and panels can be fitted)
- Undersized or badly laid-out ducts
- Ductwork that is corroded, split or holed (that needs a ductwork contractor)
If in doubt, call 0345 646 2711 or send us an email and we will say what we think before you book.
Where we work
- Access panels
- Vertical risers
- Multi-storey ducts
- Horizontal duct runs
- Bends and junctions
- Attenuators
Skinner's Hill kitchens: local notes
Skinner's Hill is within about 2 miles of the coast. Salt air speeds up corrosion of roof-level fans, discharge cowls and their fixings. According to Food Standards Agency records, there are about 6 pubs and bars within about 1.5 miles of central Skinner's Hill. A pub or hotel kitchen that cooks every day builds up grease in its extract like any other. Environmental health officers from Isle of Wight council inspect food businesses in Skinner's Hill. They look at how clean the premises and equipment are, and the kitchen extract is part of that. A dated certificate in the maintenance file answers the question before it’s asked.
A hall kitchen that only cooks for events, whether near All Saints' Church or elsewhere in Skinner's Hill, still needs its extract cleaned, just less often. If you look after a school kitchen, at a school such as Newchurch Primary School or anywhere near Skinner's Hill, the holidays are the usual time for a TR19® clean. Healthcare kitchens, like those at hospitals such as Arthur Webster Memorial Hospital for Children (about 2 miles south-east), often cook for long hours, which puts them in BESA’s heavier-use bands.
Skinner's Hill is about 5 miles south of Ryde, in the Isle of Wight. Whether your site is in the middle of Skinner's Hill or further out, ductwork cleaning is available to all kinds of commercial premises, from a single unit to a large public building. Skinner's Hill is one of 125 towns, villages and districts in the Isle of Wight we cover for ductwork cleaning. You can also see our page for Portsmouth, about 11 miles away.
Ductwork cleaning in PO36 is surveyed, quoted and booked the same way as anywhere else. Streets in the area include Skinner's Hill and Hill Top, all of which we cover for ductwork cleaning. Neighbouring places we cover for ductwork cleaning include Queen's Bower (1 mile south-east), Alverstone Garden Village (1 mile north-east), Alverstone (1 mile east), Lake (2 miles south-east) and Sandown (2 miles east). Larger places within reach include Newport (5 miles north-west), Ryde (5 miles north), Cowes (8 miles north-west), Ventnor (5 miles south), East Cowes (7 miles north-west) and Oakfield (4 miles north-east). If your site is somewhere remote, the visit takes a little more planning, so mention it when you ask for a quote.
Near you in Skinner's Hill
In Skinner's Hill, that means kitchens and buildings near Sandown Bay Academy and The Pointer Inn. The nearest railway station is Sandown station, about 1.7 miles east. Other landmarks nearby include Arthur Webster Memorial Hospital for Children (2 miles south-east) and Sandown Castle (2.3 miles east). Green spaces nearby include Alverstone Mead and Brading Down.
What affects the cost of ductwork cleaning
The diagnosis comes before the price. We look at:
- How big the system is
- Travel, parking and unloading
- Site requirements such as sign-in and permits
- Working hours and out-of-hours timing
We do not list prices on the website, because the cost depends on the site in front of us. Call for a fixed quote, and we’ll explain what it covers.
What we need to know
What to send for a quote:
- Your opening hours and when the area is out of use
- The roof, plant room or outside wall the system runs to
- Any symptoms, from odd noises to smells or leaks
- Where the site is and what kind of site it is
Here’s what helps us quote: the address, the type of site and when it’s open, a few photos and the last certificate or report, if there is one. Then phone us on 0345 646 2711 or use the quote form.
What the work involves, part by part
Access panels
We can fit new access panels where the duct needs them, so the next clean reaches more of the system. The survey shows where they’re needed.
Horizontal duct runs
Horizontal runs carry the extract along ceilings and through voids. Grease drops out of the slowing air along them, and we clean them section by section through access panels.
What we do, step by step
There are three stages on the day: set-up, the treatment itself and the sign-off. Set-up means sheeting and making equipment safe, while signing off means the written report and photos. The middle part takes longest, and that takes anything from a few hours to several visits, depending on the length of duct. We agree a date with you, plan the drive to Skinner's Hill and turn up when the site is quiet.
- First we diagnose: the route, the access and the grease levels.
- You get a fixed price before work starts.
- Each section is cleaned in turn through its access panel.
- Bends, risers and the base of each riser get extra attention.
- The duct is signed off with readings, pictures and a next clean date.
Getting ready for the visit
- Mention any locked doors, roof access or ceiling voids
- Make sure someone can let us in and lock up afterwards
- Make sure equipment near the work can be switched off and left to cool
Ask for a quote
Photos are the quickest way to a quote: the system from a couple of angles, plus any access panels or hatches. Add the site type and your opening hours, and we can price many jobs without a visit.
Read more
Places near Skinner's Hill
What else we do in Skinner's Hill
FAQs for Skinner's Hill
Do you work at weekends in Skinner's Hill?
Yes, out-of-hours work is a big part of what we do. That way a site in Skinner's Hill does not have to lose a day’s trading. When you call 0345 646 2711, or send details by email, mention when the site is quiet.
Does the sea air around Skinner's Hill make a difference to ductwork cleaning?
It can. Skinner's Hill is within about 2 miles of the coast, and salt air speeds up corrosion. Corroded fixings and housings are noted on the report so they can be dealt with.
What happens if you cannot reach some of it?
They’re listed in the report, never skipped quietly. You will know exactly which parts weren’t reached and why, along with a quote to put access in.
What types of premises do you cover?
All kinds of commercial and public premises: kitchens, offices, schools, healthcare, retail, leisure and food production. Work is timed around how each site runs.
Do you work with multi-site operators?
Yes. We work across South East England and London, so we can schedule a run of sites on one programme. Each site gets its own report and photos.
Can you quote from pictures?
Yes, if we can see what we need. Otherwise, we book a survey at a time that suits the site, and the quote follows that.
What happens if there are not enough access panels?
Sections out of reach are written down on the report, in line with TR19. New panels can be fitted to reach them in future.
Is TR19 a legal requirement?
No. TR19® is BESA’s specification, not legislation. The legal duty comes from the Regulatory Reform (Fire Safety) Order 2005: the responsible person must assess and reduce fire risk, and cleaning to TR19® is the recognised way to show grease is under control.
What staff can safely do
Staff cleaning and specialist work aren’t the same thing. Wiping filters daily and washing them weekly keeps the visible parts in order, but grease that has passed the filters is out of reach. That part needs specialist access and equipment.
Keep a record of what your team does. A dated log of in-house cleaning and checks helps show that the system is managed between specialist visits, alongside our reports.