Essex · Ductwork cleaning
Duct cleaning in Radwinter
Cleaning of kitchen extract ductwork, horizontal runs and vertical risers through access panels in Radwinter, surveyed first and signed off with a written report and photos. Call for a fixed quote.
- An insurer asking for TR19 evidence
- High readings at a recent grease test
- A rancid smell from the extract duct
About our ductwork cleaning in Radwinter
Not every duct has enough access panels. TR19 calls for any section we couldn’t reach to be recorded, and we can fit new access panels so it’s cleaned next time. It’s better to know than to assume. We are often asked to deal with readings above 200 microns from a grease thickness test and grease leaking from duct joints, on multi-storey ducts, bends and junctions and vertical risers.
Rural kitchens often have long, low duct runs through a roof space or along an outside wall, and those horizontal sections are where grease settles. We agree access and timings in advance.
Nothing is signed off by word of mouth: a dated report with photos of the work, and for TR19® Grease cleans, a certificate issued through the BESCA VHE portal. It shows what was done and what, if anything, couldn’t be reached.
- Location
- Radwinter (CB10)
- Wider area
- Essex
- Reporting
- Certificate and photo report
- Quotes
- A fixed price before we start
- When we work
- Evenings, overnight and weekends; 24/7 emergencies
- Phone
- 0345 646 2711
- Last updated
- 30 October 2026
Why act early in Radwinter
Fire inside a duct is out of sight and out of reach. The duct can carry it to rooms, floors or roof spaces well away from the kitchen, which is why the duct matters as much as the canopy. A planned visit to Radwinter is easier to arrange than an emergency callout.
When the work has to happen, how we reach it and how big the site is all affect the cost. We take each of them into account, and the price is fixed before any work starts.
Why choose Duct Doctor in Radwinter
- Every job surveyed first
- Ventilation hygiene specialists since 2009
- Evenings, overnight and weekends, plus 24/7 emergency callout
- A single point of contact for sites across the South East and London
Kitchen extracts in Radwinter
Radwinter is about 40 miles from central London, well within the area we cover across London and the South East. The visit is fixed around your opening hours, not ours. The fire and rescue service for Radwinter is Essex County Fire and Rescue Service. The Fire Safety Order puts the duty on whoever runs a kitchen to control its fire risk, and a greasy duct is fuel.
A hall kitchen that only cooks for events, whether near Church of St Mary the Virgin or elsewhere in Radwinter, still needs its extract cleaned, just less often. Kitchens that cook twelve hours or more a day, as some healthcare kitchens do, fall into BESA’s three-monthly minimum; Saffron Walden Community Hospital is the nearest hospital to Radwinter, about 3.6 miles west.
Radwinter is about 4 miles east of Saffron Walden, in Essex. Sites in Radwinter get the same service as everywhere we cover: diagnosis first, a fixed price, out-of-hours working where needed and a written report with pictures. Across Essex, we cover 644 places, and Radwinter is one of them. Chelmsford is in our area too, about 20 miles from Radwinter.
All of CB10 is within our area for ductwork cleaning, from busy streets to back roads. Streets in the area include East View Close, Water Lane and Gillon Way, and we cover them all for ductwork cleaning. If your site is just outside Radwinter, we cover The Common (1 mile north), Maple End (1 mile west), Wimbish (1 mile south-west), Hempstead (2 miles east) and Church End (3 miles north-west). Further out, we also cover Braintree (13 miles south-east), Saffron Walden (4 miles west), Halstead (14 miles east), Great Dunmow (10 miles south), Stansted Mountfitchet (10 miles south-west) and Great Notley (13 miles south-east).
What’s near Radwinter
A little further out are Castle Camps (3.3 miles north-east) and Saffron Walden Community Hospital (3.6 miles west). Green spaces nearby include West Wood.
FAQs for Radwinter
Who carries out food hygiene inspections in Radwinter?
Kitchens in Radwinter are inspected by Uttlesford council’s environmental health officers. It helps to keep the extract cleaning records with your food safety paperwork, so they’re ready if asked for.
Do you cover smaller places like Radwinter?
Yes, smaller places are covered as well as towns. The journey is planned ahead, so a few details about the route help.
Can you clean ductwork with no access panels?
Sections out of reach are written down on the report, as TR19 expects. We can fit new access panels so they’re cleaned next time.
What do you do with what you remove?
It leaves the site with us when we go. During the work, it’s contained so the area stays clean.
How is kitchen extract ductwork cleaned?
After a survey and grease readings, the duct is opened up through its access panels. Each run and riser is scraped and degreased, then the readings are repeated.
What do you need from me for a quote?
Just the basics: where it is, what kind of site, when it’s open and the access. Photos and the last report help too. After that, simply give us a ring on 0345 646 2711 or email us.
What if parts of the system cannot be reached?
We never leave them off the paperwork. You will know exactly which parts weren’t reached and why, along with a quote to put access in.
How long will the duct clean take?
A short duct can be cleaned in a few hours, but long or complex ducts may take several visits. We plan the work around your kitchen.
Common problems we fix in Radwinter
Wherever the kitchen is, in Radwinter or elsewhere, the duct fills in the same way: daily cooking hours, the menu and the state of the filters. BESA guidance sets minimum intervals of 3, 6 or 12 months depending on daily use.
Any of these means the system needs a check-up:
- Proof of duct cleaning for the insurer
- Grease leaking from duct joints
- Duct runs with no cleaning record
- Thick deposits at the bottom of a vertical duct
If you look after a school kitchen, at a school such as Radwinter Church of England Voluntary Aided Primary School or anywhere near Radwinter, the holidays are the usual time for a TR19® clean.
Before booking anyone
- When they can work, and whether that’s outside your opening hours
- Whether the price is fixed
- What insurance they carry
- What happens if part of the system can’t be accessed
Landlords, agents and facilities managers
We work for landlords, managing agents and facilities managers as well as the people running the site. Where a system serves more than one tenant, such as a shared riser, it helps to agree who arranges the work, and we can quote for the whole system.
The Fire Safety Order 2005 puts the duty to manage fire risk on the responsible person, which may be the employer, owner, landlord, FM or managing agent. With shared responsibility, good records help everyone.
When something else is needed
An honest diagnosis matters more to us than a booking, so here’s what this work can’t put right:
- Sections that can’t be reached safely without new access (those are recorded, and panels can be fitted)
- A damper stuck open in the duct
- Undersized or badly laid-out ducts
If you’re not sure, just phone us on 0345 646 2711 or drop us a line and we will give you a straight answer.
What we work on in Radwinter
- Horizontal duct runs
- Access panels
- Multi-storey ducts
- Bends and junctions
- Attenuators
- Vertical risers
The process
At the end of the visit, someone from your team can look over the work with us. Anything we couldn’t reach or that needs attention is pointed out there and then, and the same goes into the written report. All told, the work takes a few hours for a short run, longer for long runs and tall risers. Seeing the system in photos first means the trip to Radwinter can be planned properly.
- The duct route is surveyed and every access point found.
- Grease thickness is measured at set points.
- Out of hours, the area is protected and the access panels opened.
- Thick grease is scraped out, then the runs and risers are degreased.
- Panels are closed, readings and photos repeated, and unreachable sections recorded.
Before we arrive
- Let us know about parking and loading
- Tell us the best time to work, such as after service or at a weekend
- Let us know about permits to work or site inductions
Ask for a quote
We don’t publish a price list, because no two systems are the same. Instead, we look at your site first, from photos or a survey, then send a fixed quote. To get going, call 0345 646 2711 or use the quote form.
Read more
Fixed quotes for ductwork cleaning in Radwinter
The price is fixed before any work begins. It takes into account:
- Whether several sites go on one quote
- Site requirements such as sign-in and permits
- Whether we need access equipment or extra panels
- Where the site is and how we reach it
Every site is different, so we price each one individually. The size of the job, how we reach it, its condition and the working hours all make a difference.
Helping us quote
We can often survey from pictures. Try to include:
- How we’d reach plant on a roof or in a plant room
- Problems your staff have spotted
- The times we could work without disrupting the site
- The paperwork from the last visit, if you have it
Getting a quote does not take long. Send a few details and photos, and we normally reply with a fixed quote within one working day. If we need to see the system first, we book a survey around your hours.
Looking after it afterwards
Simple habits between visits make a real difference. Our advice:
- Do not switch the extract off early
- Leave a way through to the access panels
- Book the next clean before the recommended date
- Tell us if grease leaks from the ductwork
The report names every part of the duct that couldn’t be reached, with the reason. We can fit access panels so those sections are cleaned next time.
Watch for warning signs between cleans: drips from the ductwork, stale smells or a noisy fan. Testing will show whether any section has reached 500 microns.