Oxfordshire · TR19 inspections and grease testing

TR19 inspections and grease testing in Moulsford, Oxfordshire

Our technicians work in Moulsford on TR19 inspections, grease thickness testing, pre-clean surveys and post-clean verification. Fixed quotes, work around your opening hours and photo reports as standard.

  • Surveys needed before quoting a full clean
  • Insurance renewals needing proof of TR19 cleaning
  • Uncertainty over how often to clean

TR19 inspection in Moulsford

How the job changes from site to site

Vertical risers

Risers carry the extract up through the building. Grease can drain down and pool at the bottom, so the base is a key test point.

Extract fan and discharge

The extract fan and its housing collect grease too. We check and test them as part of the inspection.

TR19 inspection in Moulsford

TR19® Grease says grease should not exceed a mean of 200 microns between cleans, while a reading of 500 microns or more anywhere calls for immediate spot cleaning. Grease testing shows which side of those lines you’re on. Typical jobs include checking the result of a recent clean and cleaning intervals that may not suit the kitchen, on pre-clean surveys, post-clean checks and insurer audits.

Work in a small place like Moulsford starts with a call to agree access and timings, and the clean covers the whole system, as it would anywhere: canopy to discharge, then a TR19® certificate and a photo report.

The report is your system’s health record: a dated account with pictures of everything we did. Grease extract cleans are also certificated to TR19® Grease through the BESCA VHE portal and sits alongside the report.

Extract duct interior shown dirty and then cleaned back to bare metal
Where
Moulsford (OX10)
Region
Oxfordshire
Paperwork
Certificate and photo report
Quote
A fixed quote up front
When we work
Nights, weekends or holidays to suit you
Call
0345 646 2711
Last updated
30 October 2026

Common questions in Moulsford

Will you come out to Moulsford?

Yes. Villages and rural sites across the South East are part of our work, Moulsford included. The journey is planned ahead, so a few details about the route help.

Which council inspects kitchens in Moulsford?

Kitchens in Moulsford are inspected by South Oxfordshire council’s environmental health officers. An officer may look up into the canopy, so clean filters on the day and a recent certificate on file both help.

Do you work with multi-site operators?

Yes. Send the list of sites and the work at each and you will get one fixed quote.

What’s TR19?

A BESA specification, with two parts that matter most here: TR19® Grease for kitchen extract systems and TR19® Air for general ventilation. It isn’t law, but it’s the benchmark.

What do you need from me for a quote?

Just the basics: where it is, what kind of site, when it’s open and the access. Photos and the last report help too. Then phone us on 0345 646 2711 or drop us a line.

What about areas you cannot get to?

We record them on the report, with pictures where possible, and we explain what access is needed, for example new access panels.

What happens on a pre-clean survey?

We check the layout, the grease levels and the access, before anyone starts cleaning. Missing access panels are noted ahead of the clean.

What grease levels does TR19 allow?

Under TR19® Grease, the mean thickness should not exceed 200 microns between cleans. 500 microns or more at any point calls for immediate spot cleaning.

The process

The visit has three parts: getting the area ready, doing the work and signing it off. Set-up means sheeting and making equipment safe, and the sign-off is a written report with photos. Most of the time goes on the work itself, and that takes a couple of hours for a typical kitchen extract system. Pictures of the system and its access let us plan the work in Moulsford before we set off.

  1. We go through any past certificates and reports.
  2. We follow the extract from canopy to discharge.
  3. We note where access panels are and where more are needed.
  4. Grease readings are taken and pictures recorded.
  5. You get a report and a fixed quote for the clean.

Preparing for the visit

  • Mention any parking or loading restrictions
  • Name a contact who can let us in at the agreed time
  • Make sure equipment near the work can be switched off and left to cool

How to get a quote

Getting a quote doesn’t take long. Call or email with a few details and you will usually have a fixed price within one working day. If we need to see the system first, we book a survey around your hours.

Get a quick quote

Read more

Signs you need TR19 inspection in Moulsford

When a site in Moulsford changes owner or cleaning contractor, the records do not always follow. With no history, the current state of the extract is a guess.

If you notice any of these, it’s worth a diagnosis:

  • Missing TR19 certificates or history
  • Post-clean verification after another contractor’s clean
  • Missing access panels found on survey
  • Extracts that may be over the 200 micron mean

If you run catering at a historic house or estate in the area (Basildon Park is about 3.9 miles south), event kitchens in older buildings often have awkward duct runs that need planning.

What your quote should include

  • Whether they’re fully insured
  • Proof of accreditation you can verify
  • When the next visit should be, and why
  • If the quote is a fixed price or an estimate

Choosing a duct cleaning contractor

What happens if it’s left?

Post-clean verification shows whether the system was left the way the certificate says, before the next clean is due. Rural sites cannot always move to another kitchen or room when something fails.

Whatever the type of site, the quote works the same way: the size of the job, access, condition and working hours. Call for a fixed quote and we will explain each part.

Why us?

  • We diagnose before we treat
  • Evenings, overnight and weekends, plus 24/7 emergency callout
  • A written report with pictures after every visit
  • A fixed price before any work starts

See our cost guide or our accreditations and certificates.

What a clean won’t put right

We’d rather tell you now than book work that won’t help, so here are the limits:

  • Mechanical faults in the extract
  • Parts of the duct nobody can reach yet
  • Heavy deposits found on test, which still need cleaning

Not sure which it is? You can give us a ring on 0345 646 2711 or drop us a line and we will tell you honestly before booking.

Parts of the system we cover

  • Insurer audits
  • Deposit thickness tests
  • Pre-clean surveys
  • Access surveys
  • Post-clean checks
  • Wet film thickness tests

Moulsford kitchens: local notes

We cover Moulsford, about 46 miles from central London, as part of our work across London and the South East. A survey and a fixed quote come first, then the visit at a time that suits you. Oxfordshire Fire and Rescue Service covers Moulsford. The Fire Safety Order puts the duty on whoever runs a kitchen to control its fire risk, and a greasy duct is fuel.

Bursars and site managers at schools such as Cranford House School tend to book extract cleaning for when the kitchen is empty. A hall kitchen that only cooks for events, whether near Church of St John the Baptist or elsewhere in Moulsford, still needs its extract cleaned, just less often.

Moulsford is about 6 miles south-east of Didcot, in Oxfordshire. Whatever kind of site you run in Moulsford, we can take on TR19 inspection. Visits can be booked for evenings, overnight or weekends so the site keeps running. Our Oxfordshire coverage runs to 443 places, and Moulsford is one of them. You can also see our page for Reading, roughly 10 miles from Moulsford.

Work in OX10 is surveyed, quoted and booked the same way as anywhere else. Local streets include The Street, Glebe Close and Willow Court Lane, and we cover them all for TR19 inspection. We also cover the places around Moulsford: South Stoke (1 mile east), Cholsey (1 mile north), North Stoke (2 miles north-east), Streatley (2 miles south) and Goring (2 miles south). We also work in nearby towns such as Oxford (14 miles north), Didcot (6 miles north-west), Abingdon-on-Thames (10 miles north-west), Thame (15 miles north-east), Wantage (12 miles west) and Henley-on-Thames (11 miles east).

What’s near Moulsford

In Moulsford, that means kitchens and buildings near South Stoke Primary School and The Perch and Pike pub, among other places. Moulsford’s nearest station is Cholsey station, about 1.3 miles north. Well-known places in the area include Wallingford Castle (3.7 miles north). Not far away are Withymead Nature Reserve and Churn Hill.

Map of Moulsford © OpenStreetMap contributors

In-house cleaning or a specialist?

If your staff spot something between visits, like drips, unusual noise, smells or damaged filters, they should report it rather than try to fix it. We’ll take a look and give you a fixed quote.

For ventilation and air handling systems, in-house care is mostly about checks: clear grilles, a log of filter changes and reporting anything odd. The inside of ducts and units needs a specialist.

Between visits

After the visit, a few habits help the work last:

  • Diary the next grease test and clean
  • Keep grease filters clean and fitted properly
  • Have the latest report ready for insurance renewals
  • Tell us if menus or opening hours change

The audit report is set out to pass straight to your insurer or broker, with readings, pictures and any areas not accessible.

Close the access gaps found during inspection, so every part of the duct can be cleaned.

BESCA Vent Hygiene EliteMember, cleaning to BESA TR19® Grease
CHAS · SafeContractorISO 9001 and fully insured
Certificate and photo reportWith every clean
24/7 emergency calloutEvenings, nights and weekends
Since 2009South East England and London