Kent · Ductwork cleaning
Duct cleaning in Radfall
Specialist ductwork cleaning for Radfall: diagnosis first, then a fixed quote, the work and a report with pictures. Ask us for a fixed quote.
- Thick deposits at the bottom of a vertical duct
- A duct clean needed for an insurer
- A duct nobody has opened in years
When it’s something else
Ductwork cleaning cannot fix everything, and we’ll tell you before work begins. It will not put right:
- Leaking duct joints that need repair
- A worn-out fan that needs replacing
- Duct sealed behind fixed ceilings or walls
Not sure which it is? You can call us on 0345 646 2711 or send us an email and we’ll tell you honestly before booking.
What the work covers
- Vertical risers
- Access panels
- Horizontal duct runs
- Multi-storey ducts
- Attenuators
- Bends and junctions
Ductwork cleaning in Radfall
Duct cleaning is the hardest part of an extract clean, and the part most often skipped. Without enough access panels, long stretches can go years without being touched. Each section we can reach is cleaned, and any we cannot is written down, so you know exactly where you stand. The work covers attenuators, bends and junctions and horizontal duct runs, and people most often call us about thick crusts of old grease along the duct and a rancid smell from the extract duct.
In a small place like Radfall, kitchens are often in older or extended buildings, with long single-storey duct runs, where grease settles in the flat sections. We agree access and timings in advance.
The report is your system’s health record: a dated account with photos of everything we did. Grease extract cleans are also certificated to TR19® Grease through the BESCA VHE portal and sits alongside the report.
- Where
- Radfall (CT5)
- Wider area
- Kent
- Records
- Certificate plus before-and-after pictures
- Quote
- Fixed quote, usually within a working day
- Hours
- Out of hours as standard, 24/7 emergency line
- Call
- 0345 646 2711
- Page updated
- 30 October 2026
Nearby places to Radfall
What else we do in Radfall
When to call us in Radfall
Risers carry the extract up through the building. Grease collects on the riser walls and gathers at the bottom, where it can pool. Panels along the riser make proper cleaning possible.
It’s time to book a visit if you see:
- Duct runs with no cleaning record
- A rancid smell from the extract duct
- Years of grease along the duct floor
- Grease pooling at the foot of the riser
Kitchens that cook twelve hours or more a day, as some healthcare kitchens do, fall into BESA’s three-monthly minimum; Whitstable and Tankerton Hospital is the nearest hospital to Radfall, about 1.8 miles north-west.
Comparing quotes
- How they set the interval to the next visit
- Proof of accreditation you can verify
- Whether a written report and photos are included
- What’s included in the scope, part by part
What your team can do, and what needs us
Staff cleaning doesn’t replace a specialist visit; it supports it. Clean filters and tidy surfaces slow the build-up, but hidden parts of the system still need specialist attention.
If your staff spot something between visits, like drips, unusual noise, smells or damaged filters, it’s best reported rather than tackled in-house. We’ll take a look and give you a fixed quote.
Radfall questions
Which fire service covers Radfall?
Radfall is in the area of Kent Fire and Rescue Service. Records of extract cleaning are a sensible thing to have ready if a fire safety officer carries out an audit.
Do you cover smaller places like Radfall?
Yes, Radfall is part of our area, however small the site. Let us know about access, parking and anything unusual about getting there when you book.
How do you know if the ductwork needs cleaning?
Start with the date of the last clean. No record, or a passed date, means it’s due, and grease readings will confirm how urgent it is.
What’s the cleaning interval for extract ductwork?
The duct is cleaned as part of the whole system, at intervals set by BESA guidance, from every 3 months for heavy use to every 12 months for light use. Readings tell you if it needs to be more often.
Do you offer emergency callouts?
Yes. For anything urgent, such as a fan failure or damage after a fire, ring the 24/7 line and we’ll talk you through the next steps.
How much notice should we give?
Book as early as you can for planned work, particularly if your next visit is nearly due. Emergencies are different, because our line is open 24/7.
Can you price the work without visiting?
Yes, for many jobs. Send wide shots, close-ups of any access panels and anything that worries you, and we usually come back within one working day. Some sites still need a visit, and we’ll say so.
Do you install duct access panels?
Yes, we install duct access panels. Panels go where they give the best access to sections that couldn’t be reached, and we will recommend where.
Ductwork cleaning in Radfall: the local picture
Sea air reaches Radfall, which sits within about 2 miles of the coast. Salt in the air is hard on rooftop fans, discharge cowls and fixings, so we check them for corrosion as well as grease. The FSA’s food hygiene register shows about 5 restaurants, cafés and canteens within roughly a mile and a half of the centre of Radfall. The duct above a busy canopy coats itself in grease long before anyone sees it. Kent Fire and Rescue Service covers Radfall. In most workplaces, including commercial kitchens, it’s the fire and rescue authority that enforces the Fire Safety Order.
If you look after a school kitchen, at a school such as The Whitstable School or anywhere near Radfall, the holidays are the usual time for a TR19® clean.
Radfall is about 2 miles south-east of Whitstable, in Kent. Wherever you are in the CT5 postcode area, we can carry out ductwork cleaning at your premises. Radfall is one of 922 towns, villages and districts in Kent where we work for commercial clients. For sites nearby, see our Maidstone page (24 miles or so).
Work in CT5 follows the same survey, fixed quote and written report as everywhere else we cover. You will find streets such as Radfall Road, Broomfield Gate and Dukeswood, and we cover them all for ductwork cleaning. If your site is just outside Radfall, we cover Chestfield (1 mile north), West End (1 mile north-east), Swalecliffe (2 miles north), Whitstable (2 miles north-west) and Tankerton (2 miles north-west). Within a short drive, we also cover Canterbury (4 miles south), Margate (14 miles east), Sittingbourne (14 miles west), Ramsgate (15 miles east), Faversham (8 miles west) and Herne Bay (4 miles north-east).
Local landmarks in Radfall
The nearest railway station is Chestfield & Swalecliffe station, roughly 1.5 miles north. Other landmarks nearby include Tankerton Castle (2.3 miles north-west) and Sidney Cooper Museum (4 miles south). The countryside around Radfall includes West Blean and Thornden Woods.
What the work involves, part by part
Bends and transitions
Grease tends to pile up at elbows. It’s scraped out and degreased, and test it before and after.
Access panels
Extra panels can be installed where there are gaps, making future cleans more complete. We will recommend where they should go.
How it works
Our technicians bring everything the work needs, from protective sheeting to tools and access equipment. You only need to give us clear access and switch off what needs to be off. On site, the work takes from a few hours to more than one visit, depending on duct length and access. For a village or hamlet like Radfall, tell us about narrow lanes, gates and parking when you book.
- First the duct route is traced and every access point noted.
- We measure grease thickness at set points before cleaning.
- We open the panels and scrape out the heaviest grease.
- Next the ducts and risers are degreased, using whatever suits the deposit.
- We test again, take photos and note any part that couldn’t be reached.
Getting ready for the visit
- Have your last certificate or report to hand
- Arrange a key holder or contact on site
- Tell us about site rules, permits or sign-in
Ask for a quote
The quickest way to a quote is to send pictures: wide shots of the system, close-ups of anything that worries you and how we’d get to it. Add the site type and your opening hours, and we can price many jobs without a visit.
Read more
Why it’s worth doing now in Radfall
Grease narrows the duct and slows the air. Less air moves, so heat and smoke stay in the kitchen while the fan strains, and grease may start to leak from joints. In a place like Radfall, ductwork and fans are easy to forget until something goes wrong.
What you pay reflects the actual work. That’s why every job is surveyed first, and why the quote is fixed before any work starts.
Why book with us
- A written report with pictures after each visit
- Full insurance on every job
- In business since 2009
- BESCA Vent Hygiene Elite member, cleaning to BESA TR19® Grease
Looking after it afterwards
Once we’ve finished, these simple steps help:
- Store the certificate with the fire risk assessment
- Flag drips from the duct right away
- Make sure filters are seated properly
- Have the grease measured if cooking hours go up
A full system clean includes a TR19 certificate from the BESCA Vent Hygiene Elite portal. It shows when and where the clean was done and by whom.
The less grease gets past the canopy, the cleaner the duct stays. Clean, properly seated filters are the duct’s best protection.