Hampshire · Ductwork cleaning
Ductwork Cleaning in Gilbert Street
For cleaning of kitchen extract ductwork, horizontal runs and vertical risers through access panels in Gilbert Street, one call is all it takes, from survey to sign-off. CHAS and SafeContractor accredited, ISO 9001 and fully insured.
- Thick deposits at the bottom of a vertical duct
- Grease leaking from duct joints
- A duct clean needed for an insurer
FAQs for Gilbert Street
Can you get to a site in Gilbert Street?
Yes, Gilbert Street is part of our area, however small the site. The journey is planned ahead, so a few details about the route help.
Which fire authority looks after Gilbert Street?
It’s Hampshire and Isle of Wight Fire and Rescue Service, which covers Gilbert Street. If a fire safety officer visits a commercial kitchen, they may ask about the fire risk assessment and how the extract is kept clean.
What’s involved in cleaning extract ducts?
Through access panels along the duct. Thick deposits are removed by hand before degreasing, such as degreasers, hot water or steam.
What happens if you can’t reach some of it?
We record them on the report, with a note of where it is, and we explain what access is needed, for example new access panels.
What do you do with what you remove?
Waste is contained during the work and removed when we leave, including grease, debris and dirty water. None of it is left on site.
Can we book visits on a schedule?
Yes. Regular plans can run on 3, 6 or 12-monthly cycles, to suit the system and how it’s used.
How often should kitchen ducts be cleaned?
The duct is cleaned as part of the whole system, at intervals set by BESA guidance, from every 3 months for heavy use to every 12 months for light use. Readings tell you if it needs to be more often.
What if part of the duct can’t be reached?
Sections out of reach are written down on the report, as TR19 expects. New panels can be fitted to reach them in future.
About our ductwork cleaning in Gilbert Street
No two duct runs are the same, in Gilbert Street or anywhere else. A few metres to an outside wall, or a riser up through the building to a roof fan. The survey traces the route, so we know where to get in and how long it will take. We’re often asked to deal with high readings at a recent grease test and proof of duct cleaning for the insurer, across horizontal duct runs, access panels and vertical risers.
Work in a small place like Gilbert Street starts with a call to agree access and timings, and the clean itself is the same full TR19® job as in any town: canopy to discharge, then a TR19® certificate and a photo report.
Accreditations are easy to claim and worth checking. We’re a BESCA Vent Hygiene Elite member, cleaning to BESA TR19® Grease, and we hold CHAS, SafeContractor and ISO 9001, and we are fully insured.
- Place
- Gilbert Street (SO24)
- Region
- Hampshire
- Records
- TR19® certificate and photo report
- Price
- Fixed quote, usually within a working day
- Working hours
- Nights, weekends or holidays to suit you
- Call
- 0345 646 2711
- Page updated
- 30 October 2026
Places near Gilbert Street
More services for Gilbert Street
How the job changes from site to site
Vertical risers
Risers often pass through floors and walls, so fire dampers may be fitted where it crosses them. Damper testing is a separate service.
Horizontal duct runs
Long horizontal runs need access panels at regular intervals. Any stretch out of reach is noted and can fit extra panels.
For landlords and multi-site operators
Where a tenant occupies the premises but the landlord owns the building, it’s worth checking the lease for who maintains the systems. We are happy to deal with either side, and the report can go to both.
We also work for facilities teams across offices, schools and healthcare across Hampshire. Larger estates can be phased building by building around the people who use them.
Why act early in Gilbert Street
A partly blocked duct slows the airflow. Less air moves, so heat and smoke stay in the kitchen while the fan strains and grease can drip from duct joints. In a place like Gilbert Street, ductwork and fans are easy to forget until something goes wrong.
Several systems or sites on one quote can make for a more efficient booking. Tell us about everything you’d like looked at and we’ll price it together.
Why us?
- We diagnose before we treat
- One number for every site across the South East and London
- Evenings, overnight and weekends, plus 24/7 emergency callout
- Member of BESCA Vent Hygiene Elite, cleaning to BESA TR19® Grease
See what affects the cost and our accreditations.
When to call us in Gilbert Street
Grease filters that don’t seal let fat straight through. The duct then takes grease that the filters should have stopped, and build-up speeds up.
These are the problems we see most often:
- Fat dripping from the ductwork
- High readings at a recent grease test
- Duct runs that cannot be reached
- Grease pooling at the foot of the riser
If you run catering at a healthcare site, such as a hospital like Alton Community Hospital about 4.8 miles north-east, the extract may need cleaning more often than a part-time kitchen.
What to look for in a quote
- Proof of accreditation you can verify
- What records you will receive afterwards
- How they set the interval to the next visit
- Whether the work can be done while the site is closed
How it works
Protection comes first: sheeting goes over floors and surfaces close to the work. After that, the system is made safe and the work begins. It takes a few hours for a short run, longer for long runs and tall risers, and we clear up before we go. Visits to a village like Gilbert Street are booked in advance, at a time that suits whoever runs the site.
- First we diagnose: the route, the access and the grease levels.
- A fixed quote follows, based on what we found.
- We clean section by section, working from panel to panel.
- Bends, risers and the base of each riser get extra attention.
- The duct is signed off with readings, photos and a next clean date.
Getting ready for the visit
- Agree a time when the area can be out of use
- Mention any locked doors, roof access or ceiling voids
- Find the previous report, if there is one
Getting a quote
Getting a quote doesn’t take long. Send a few details and pictures, and we typically reply with a fixed quote within one working day. If we need to see the system first, we book a survey around your hours.
Advice
Ductwork cleaning around Gilbert Street
Gilbert Street is about 51 miles from central London, well within the area we cover across London and the South East. Evening, overnight and weekend visits are all possible. It’s East Hampshire council that sends environmental health officers to food businesses in Gilbert Street. They look at how clean the premises and equipment are, and the kitchen extract is part of that. A TR19® certificate and photo report after each clean gives you a record to show an inspector.
If you run catering at a historic house or estate in the area (Bentworth Hall is about 4.2 miles north), event kitchens in older buildings often have awkward duct runs that need planning. School kitchens, at schools like Ropley Church of England Primary School for example, are normally cleaned in the holidays so no lunches are lost.
Gilbert Street is about 6 miles south-west of Alton, in Hampshire. From the centre of Gilbert Street to the outskirts, ductwork cleaning is available to all kinds of commercial premises, from a single unit to a large public building. Across Hampshire, we cover 683 places, and Gilbert Street is one of them. Southampton is in our area too, about 18 miles from Gilbert Street.
All of SO24 is within our area for ductwork cleaning, from busy streets to back roads. Streets in the area include Andrew's Lane, Gilbert Street and Swelling Hill, and we cover them all for ductwork cleaning. Close by, we work in Ropley (1 mile south-west), Kitwood (1 mile north-east), North Street (1 mile north-west), Charlwood (1 mile south-east) and Ropley Dean (1 mile west). Within a short drive, we also cover Basingstoke (12 miles north), Winchester (11 miles west), Eastleigh (15 miles south-west), Horndean (13 miles south), Alton (6 miles north-east) and Waterlooville (14 miles south).
Local landmarks in Gilbert Street
Well-known places in the area include Barton Castle (4.1 miles north-west) and Alton Community Hospital (4.8 miles north-east). For a walk, there’s Shutts Copse and Red Hill.
What affects the quote in Gilbert Street
There’s no set price list, because no two systems are the same. The quote depends on:
- The condition we find in the survey
- How big the system is
- Site requirements such as sign-in and permits
- A single visit or a regular plan
One small site or a whole estate, the quote is built the same way: the work involved, the access and the timing. You will have a fixed price before work begins.
Asking for a quote
When you contact us, these details help:
- Photos showing the whole system and its surroundings
- The site address and the type of premises
- Where the plant sits or the system leaves the building, such as a roof or outside wall
- Close-ups of filters, grilles, hatches or access panels
For ductwork cleaning in Gilbert Street, phone us on 0345 646 2711 or send us an email. Let us know the site type and the opening hours, and send photos or your last report if you can. A fixed quote typically follows within one working day.
Honest limits
An honest diagnosis matters more to us than a booking, so here’s what this work can’t put right:
- Ductwork that is corroded, split or holed (that needs a ductwork contractor)
- A damper stuck open in the duct
- Parts of the duct with no way in
Not sure which it is? You can phone us on 0345 646 2711 or send us an email and we’ll tell you honestly before you book.
Where we work
- Bends and junctions
- Attenuators
- Vertical risers
- Access panels
- Multi-storey ducts
- Horizontal duct runs