Essex · TR19 inspections and grease testing
TR19 Inspection in Fuller's End
We cover Fuller's End for TR19 inspections, grease thickness testing, pre-clean surveys and post-clean verification. Fixed quotes, work around your opening hours and photo reports as standard.
- Kitchen extract systems with no recent grease readings
- Sections of duct that cannot be reached
- Kitchens whose menu or hours have changed
TR19 inspection in Fuller's End, done properly
Insurance policies often require evidence of TR19® cleaning and inspection. Missing records can lead to a claim being reduced or refused. A TR19 audit sets out the system’s condition, with readings and photos, for sites in Fuller's End and the rest of Essex. We are often asked to deal with extracts that have never been grease tested and insurers asking for TR19 evidence, on deposit thickness tests, wet film thickness tests and pre-clean surveys.
For a kitchen in or near Fuller's End, the visit is planned around opening hours and the journey, and the clean itself is the same full TR19® job as in any town: canopy to discharge, then a TR19® certificate and a photo report.
Think of the report as the system’s health record: a dated account with pictures of everything we did. For TR19® Grease cleans, the certificate comes through the BESCA Vent Hygiene Elite portal and sits alongside the report.
- Where
- Fuller's End (CM22)
- Wider area
- Essex
- Records
- TR19® certificate and photo report
- Quote
- Fixed quote, normally within a working day
- Hours
- Out of hours as standard, 24/7 emergency line
- Phone
- 0345 646 2711
- Last updated
- 30 October 2026
Part by part
Horizontal duct runs
If a run has no access panel, we note it so panels can be added.
Canopy and plenum
We look over the canopy, inside and out, and note where grease has gathered.
Do you need TR19 inspection in Fuller's End?
Kitchens change: a new menu, longer hours or more frying can all add grease. A cleaning interval set years ago may no longer fit.
Keep an eye out for these warning signs:
- Surveys needed before quoting a full clean
- Missing TR19 certificates or history
- Missing access panels found on survey
- Heavy grease suspected in the plenum or ducts
Where a hall near Church of St Mary the Virgin, or anywhere in Fuller's End, hosts lunch clubs or events, its extract gathers grease just as a café’s does.
What to look for in a quote
- What hours they’ll be on site
- Whether the figure could change on the day
- When the next visit should be, and why
- What’s included in the scope, part by part
Grease, kitchens and Fuller's End
The FSA’s food hygiene register shows about 3 restaurants, cafés and works canteens within 1.5 miles or so of the middle of Fuller's End. A WFTT or DTT reading tells each of those kitchens whether its grease is staying under the 200-micron mean. Fuller's End is covered by Essex County Fire and Rescue Service. Grease in a kitchen extract is a recognised fire risk, and the fire authority enforces the law on managing it in most commercial premises. Kitchens in Fuller's End get their food hygiene inspections from Uttlesford council. An officer looking round a kitchen will see the canopy, and grease there is hard to miss. Keeping each certificate and photo report on file helps show the extract is looked after.
Term dates shape school work: for a school like Forest Hall School, an extract clean fits neatly into a half-term or summer break. Healthcare kitchens, like those at hospitals such as Herts and Essex Hospital (about 3.9 miles south-west), often cook for long hours, which puts them in BESA’s heavier-use bands.
Fuller's End is about 4 miles north-east of Bishop's Stortford, in Essex. Fuller's End gets the same approach as every site we work on: diagnosis first, a fixed price, out-of-hours working where needed and a written report with photos. Across Essex, we cover 644 places, and Fuller's End is one of them. Chelmsford is in our area too, around 16 miles away.
Every address in CM22 is covered for TR19 inspection, from the main roads to the quietest streets. Other places close to Fuller's End include Elsenham (1 mile north-west), Ugley Green (1 mile north-west), Henham (2 miles north-east), Brick End (2 miles east) and Ugley (2 miles north-west). Within a short drive, we also cover Braintree (14 miles east), Harlow (11 miles south-west), Saffron Walden (8 miles north), Great Dunmow (6 miles south-east), Epping (15 miles south) and Great Notley (13 miles east).
Around Fuller's End
We work in commercial kitchens and buildings around Robin Hood Public House, among other places. The closest station to Fuller's End is Elsenham station, about 0.8 miles north. Nearby you will also find House On The Hill Toy Museum (1.3 miles west) and Herts and Essex Hospital (3.9 miles south-west). The countryside around Fuller's End includes Portingbury Hills and Aubrey Buxton Nature Reserve.
What happens on the day
When we arrive, we check the system against the survey or the photos you sent. If anything is different, we talk it through with the person on site before carrying on. From there, it takes an hour or two for a single kitchen, longer for a large or complex system. The timing of a visit to Fuller's End is set by you, and the travel is our side of the planning.
- First we book a time that won’t disrupt cooking.
- Every part of the system is examined, end to end.
- We take WFTT or DTT readings at set points along the system.
- Photos are taken at each point, and access gaps noted.
- You get a report with readings, photos and recommendations.
How to prepare
- Tell us about access, such as roof hatches, plant rooms, ceilings or locked areas
- Make sure someone can let us in and lock up afterwards
- Mention any parking or loading restrictions
Getting a quote
Some systems can be priced from photos; others need a survey. Larger sites, and anything hidden behind walls, ceilings or floors, are normally surveyed first. Either way, the quote is fixed before any work is booked.
Read more
What a clean won’t put right
TR19 inspection cannot fix everything, and we’d rather say so up front. It won’t put right:
- Hidden runs that need access panels first
- Removing the grease, which is a separate clean
- Mechanical faults in the extract
Not sure which it is? You can call us on 0345 646 2711, or email photos and we will tell you honestly before booking.
What we work on in Fuller's End
- Deposit thickness tests
- Post-clean checks
- Wet film thickness tests
- Insurer audits
- Pre-clean surveys
- Access surveys
Places near Fuller's End
More services for Fuller's End
Your questions about TR19 inspection in Fuller's End
Can a school canteen extract in Fuller's End be done out of term time?
Yes. Half-terms and the summer break are the natural time for school work. With about 2 schools and colleges on the FSA’s register within roughly a mile and a half of Fuller's End, it pays to plan holiday dates ahead. You can ring 0345 646 2711, or send details by email with the dates the site is empty.
Will you come out to Fuller's End?
Yes, smaller places are covered as well as towns. A survey first, from photos or a visit, means we arrive with the right kit.
What happens to the waste?
We take it away when we go. While we work, it’s kept contained to keep the area clean.
What about areas you can’t get to?
We never leave them off the paperwork. The report says which parts couldn’t be reached and why, along with a quote to put access in.
What happens on a pre-clean survey?
It’s a look at the whole extract before it’s cleaned, with readings and photos. We can work from photos and details, or visit, whichever suits the system.
Can you quote from pictures?
Usually, yes. Send a few wide photos plus close-ups of panels, filters or grilles, and we usually come back within one working day. If pictures are not enough, we will survey first.
What is a WFTT or DTT grease test?
Grease thickness testing measures the layer of grease on the duct surfaces, by WFTT or DTT. Each reading is recorded in microns.
What does TR19 mean?
It’s the industry benchmark for cleaning ventilation and kitchen extract systems, written by BESA. It sets out inspection, cleaning and record keeping and expects a risk-based approach.
For landlords and multi-site operators
Whether it’s one building or many, the standard is the same: a survey first, a fixed quote, the work timed around the site and a report with pictures.
When the building owner and the occupier are different, the lease normally sets out who maintains what. We are happy to deal with either side and send the paperwork to whoever needs it.
How we price TR19 inspection
A fixed price needs a few facts first. We look at:
- Site rules, permits and inductions
- When the work can happen, such as evenings, overnight or weekends
- How many systems or sites are involved
- One-off work versus a regular cycle
No two sites are the same, so we price each one individually. The size of the job, how we reach it, its condition and the working hours all play a part.
Helping us quote
The more you tell us, the more accurate the quote. With your enquiry, please include:
- Wide photos of the system and the area around it
- Detail shots of panels, filters and grilles
- How we’d reach plant on a roof or in a plant room
- Your opening hours and when the area is out of use
For a fixed quote, phone us on 0345 646 2711 or use the quote form with the site type, your trading hours and a short description of the system. Photos and the last report, if you have one, make the quote quicker. You’ll normally have a quote within one working day.
Aftercare tips
A little care between visits keeps the system in better shape. Our advice:
- Share inspection reports with your insurer or broker when asked
- Keep access panels clear and unpainted
- Flag oily drips near the extract
- Keep canopy edges and gutters wiped down
If any reading is 500 microns or more, the report flags it for immediate spot cleaning, and we can arrange it.
Clean, correctly fitted filters stop more grease reaching the duct. Missing or damaged filters let grease straight into the plenum.