Essex · Ductwork cleaning
Ductwork cleaning in Mill Street, Essex
Ductwork cleaning in Mill Street, surveyed first and signed off with a written report and pictures. Ask us for a fixed quote.
- Thick crusts of old grease along the duct
- An insurer asking for TR19 evidence
- Grease seeping out of the duct seams
Ductwork cleaning in Mill Street
No two duct runs are the same, in Mill Street or anywhere else. A few metres to an outside wall, or a riser up through the building to a roof fan. The survey traces the route and finds every access point before we quote. If you have a duct nobody has opened in years and readings above 200 microns from a grease thickness test, we can help, from access panels, attenuators and bends and junctions onwards.
In a village or hamlet like Mill Street, the kitchens that need extract cleaning are normally a pub, a school, a care home or a hall kitchen, wherever there is one. Every one of them still needs its extract kept clear of grease.
Think of the report as the system’s health record: dated, with pictures, and showing what was done. Grease extract cleans are also certificated to TR19® Grease through the BESCA VHE portal and sits alongside the report.
- Where
- Mill Street (CO6)
- Region
- Essex
- Paperwork
- Certificate plus before-and-after pictures
- Quote
- Fixed quote, normally within a working day
- Hours
- When your site is closed, plus a 24/7 line
- Call
- 0345 646 2711
- Updated
- 30 October 2026
Between visits
Here’s the after-treatment advice, short and simple:
- Keep grease filters clean and fitted whenever you cook
- Book the next clean before the recommended date
- Have the grease measured if cooking hours go up
- Keep access panels clear of stored items
Every panel we open is refitted when we finish, and the area around them is cleaned down. Waste grease and water are taken away.
Run the extract the whole time the kitchen is cooking. Moving air carries vapour through rather than letting it settle, so switching off early adds to the build-up.
What your team can do, and what needs us
Keep a record of what your team does. A simple log of filter washes, wipe-downs and checks shows an inspector that the system is looked after between visits, next to our reports.
Staff cleaning doesn’t replace a specialist visit; it supports it. Clean filters and tidy surfaces slow the build-up, but the parts you cannot see still need a specialist at the right interval.
The process
Each visit runs to the same pattern: sheeting and protection first, make the system safe, do the work, clear away and leave you the report. The visit itself takes anything from a few hours to several visits, depending on the length of duct. Somewhere as small as Mill Street, the date and timings are agreed with you well before the day.
- We trace the duct and find every way in.
- Grease thickness is measured at set points.
- Out of hours, the area is protected and the access panels opened.
- Heavy deposits come out by hand, then each section is degreased.
- We close up, re-test, photograph and record anything out of reach.
Before we arrive
- Make sure someone can let us in and lock up afterwards
- Have your last certificate or report to hand
- Let us know how we reach the system, including roofs, risers and plant rooms
How to get a quote
Need a price for ductwork cleaning? Please phone us on 0345 646 2711, or send details by email and tell us about the site. We’ll explain what we’d do and send a fixed quote before anything is booked.
Read more
What happens if it’s left?
BESA guidance says grease shouldn’t exceed a mean of 200 microns between cleans. A reading of 500 microns or more at any point means a spot clean straight away. Putting off the clean only pushes readings higher. It’s worth booking a check, because nobody sees inside a duct day to day.
A single site or a whole portfolio, we price it on the same basis: the work involved, the access and the timing. The price is fixed before work begins.
What you get with us
- Member of BESCA Vent Hygiene Elite, cleaning to BESA TR19® Grease
- We diagnose before we treat
- Ventilation hygiene specialists since 2009
- Fully insured
See our cost guide and our accreditations.
For landlords and multi-site operators
We regularly work with managing agents. Send the address, what’s needed and how access works, and we will send a fixed quote.
Keeping records across a portfolio is half the battle. Each visit ends with a dated report and photos, ready to show insurers, fire officers or EHOs.
When something else is needed
To be straight with you, there are a few things this work won’t fix:
- Duct sealed behind fixed ceilings or walls
- An extract fan that has stopped working
- A duct that is too small or badly routed for the kitchen (a design issue)
If you’re not sure, just call 0345 646 2711 or drop us a line and we’ll give you a straight answer before booking.
Where we work
- Multi-storey ducts
- Bends and junctions
- Attenuators
- Access panels
- Vertical risers
- Horizontal duct runs
Your questions about ductwork cleaning in Mill Street
Who enforces fire safety at workplaces in Mill Street?
It’s Essex County Fire and Rescue Service, which covers Mill Street. If a fire safety officer visits a commercial kitchen, they may ask about the fire risk assessment and how the extract is kept clean.
Is Mill Street within the area you cover?
Yes. Mill Street is within the area we cover across London and the South East. Just mention lanes, gates or anything else about the site when you book.
Can you clean ductwork with no access panels?
Sections out of reach are written down on the report, in line with TR19. We can fit new access panels so they’re cleaned next time.
Do you work with multi-site operators?
Yes. Tell us the addresses and what each needs and you’ll get one fixed quote.
How long does it take to clean extract ducts?
It takes anything from a few hours to several visits, depending on the length of duct. We’ll confirm the time when we quote.
How much does ductwork cleaning cost in Mill Street?
We do not publish prices, because the cost depends on the job: how big it is, what state it’s in, how we reach it and the working hours. You get a fixed price before we start.
How is kitchen extract ductwork cleaned?
Through access panels along the duct. Thick deposits are removed by hand before degreasing, such as degreasers, hot water or steam.
Will the duct clean disrupt the kitchen?
The duct is cleaned out of hours, so evenings, nights and weekends are all possible. Equipment and the extract are switched off while we work.
When to call us in Mill Street
Air cools as it moves away from the canopy. As it cools, the grease it carries condenses onto the duct walls, which is why ducts go on gathering grease well beyond the filters.
It’s time to book a visit if you see:
- Fat dripping from the ductwork
- Smells of old cooking grease from the ductwork
- Hardened, baked-on grease in long horizontal runs
- Duct runs that cannot be reached
School kitchens, at schools like Stoke-by-Nayland Church of England Primary School for example, are normally cleaned in the holidays so no lunches are lost.
What your quote should include
- Whether a survey comes first
- Proof of insurance
- What hours they’ll be on site
- Whether the figure could change on the day
Kitchen extracts in Mill Street
Mill Street is about 55 miles from central London, well within the area we cover across London and the South East. A survey and a fixed quote come first, then the visit at a time that suits you. In Mill Street, food businesses are inspected by environmental health officers from Babergh council. An officer looking round a kitchen will see the canopy, and grease there is hard to miss. Our report lists what was cleaned and when, which is useful to have ready.
Kitchens that cook twelve hours or more a day, as some healthcare kitchens do, fall into BESA’s three-monthly minimum; Severalls Hospital is the nearest hospital to Mill Street, about 5.7 miles south. If you run a church or community hall kitchen, near Church of St Mary or elsewhere in Mill Street, its extract still collects grease from every lunch and event.
Mill Street is in Essex. Mill Street gets the same approach as every site we work on: a survey first, a fixed quote, work timed around your hours and a report with photos. Our area takes in 644 places across Essex, from busy centres to quieter spots. Chelmsford is in our area too, about 25 miles from Mill Street.
All of CO6 is covered for ductwork cleaning, from the main roads to the quietest streets. You’ll find streets such as Mill Street and Mill Lane, all of which we cover for ductwork cleaning. Larger places within reach include Colchester (8 miles south), Camulodunum (8 miles south), Halstead (12 miles west), Greenstead (8 miles south), Tiptree (14 miles south-west) and Wivenhoe (10 miles south).
What’s near Mill Street
We work in commercial kitchens and buildings around Bells Corner pub. A little further out are Severalls Hospital (5.7 miles south) and Lindsey Castle (4.1 miles north). Not far away are Arger Fen.