Essex · Ductwork cleaning
Ductwork Cleaning in Horsley Cross
Ductwork cleaning across Horsley Cross and nearby, booked around your opening hours and signed off in writing with pictures.
- Grease leaking from duct joints
- Sections of duct with no access panels
- A duct clean needed for an insurer
Ductwork cleaning in Horsley Cross, done properly
Ductwork in Horsley Cross is cleaned the same thorough way as everywhere else we work: readings at set points, heavy grease scraped out by hand, then degreasing to suit the deposit. Readings are taken again afterwards and photos go into your report. We’re often asked to deal with stale grease odours from the duct and grease pooling at the foot of the riser, across vertical risers, horizontal duct runs and access panels.
Rural kitchens often have long, low duct runs through a roof space or along an outside wall, and those horizontal sections are where grease settles. Access, parking and timings are agreed before the day.
Nothing is signed off by word of mouth: a dated report with photos of the work, plus a certificate through the BESCA Vent Hygiene Elite portal when the work is a TR19® Grease clean. It shows what was done and what, if anything, couldn’t be reached.
- Where
- Horsley Cross (CO11)
- Wider area
- Essex
- Reporting
- Certificate plus before-and-after pictures
- Quote
- A fixed quote up front
- Hours
- After hours by arrangement; emergencies any time
- Phone
- 0345 646 2711
- Checked
- 30 October 2026
Grease, kitchens and Horsley Cross
Sea air reaches Horsley Cross, which sits within about 3 miles of the coast. Salt air speeds up corrosion of roof-level fans, discharge cowls and their fixings. Kitchens in Horsley Cross get their food hygiene inspections from Tendring council. The cleanliness of the kitchen and its equipment, extraction included, is part of what they check. Our report lists what was cleaned and when, which is useful to have ready. The fire and rescue service for Horsley Cross is Essex County Fire and Rescue Service. Its fire safety officers can audit commercial kitchens, and grease in the extract is part of a kitchen’s fire risk.
If your kitchen is in a listed or historic building, like the houses around Horsley Cross (Castle House is about 4.9 miles north-west), fitting access panels needs care. Whether the kitchen is in Horsley Cross itself or nearby, a TR19® clean covers the whole system, canopy to discharge.
Horsley Cross is about 8 miles north of Clacton-on-Sea, in Essex. Whether your site is in the middle of Horsley Cross or further out, we cover ductwork cleaning for every kind of premises, from small sites to large estates. 644 places in Essex are on our list, large and small. Chelmsford is in our area too, around 28 miles away.
Ductwork cleaning in CO11 is surveyed, quoted and booked the same way as anywhere else. We also cover Horsleycross Street (1 mile north), Little Bromley (2 miles north-west), Mistley (3 miles north), Manningtree (3 miles north) and Lawford (3 miles north-west). Within a short drive, we also cover Colchester (8 miles west), Clacton-on-Sea (8 miles south), Harwich (8 miles east), Camulodunum (9 miles west), Greenstead (6 miles west) and Wivenhoe (6 miles south-west).
Around Horsley Cross
In Horsley Cross, that means kitchens and buildings near The Cross Inn, among other places. The closest station to Horsley Cross is Mistley station, about 2.7 miles north. For a walk, there’s Wrabness Nature Reserve.
Horsley Cross questions
Will you come out to Horsley Cross?
Yes. Horsley Cross is within the area we cover across London and the South East. Photos of the system and directions to the site help us plan the visit.
Does coastal air change anything about ductwork cleaning in Horsley Cross?
It can. Being within about 3 miles of the sea means more corrosion on metalwork in Horsley Cross than inland. We look at fans, cowls and fixings for rust as well as grease.
What happens if you cannot reach some of it?
We never leave them off the paperwork. You will know exactly which parts weren’t reached and why, and we can quote to improve the access.
How far ahead should we book?
The more notice, the better, particularly for night and weekend visits. Quotes normally come back within one working day, and emergencies are covered by our 24/7 line.
What does TR19 mean?
TR19® is the BESA specification for keeping ventilation systems clean. Since 2019, TR19® Grease has been a standalone specification for grease in kitchen extract systems, while TR19® Air covers other supply and extract ductwork.
How long does it take to clean extract ducts?
It takes a few hours for a short run, longer for long runs and tall risers. We’ll confirm the time when we quote.
Are you fully insured?
Yes, fully. CHAS and SafeContractor accreditation sit alongside it for clients who vet their contractors.
Do you work with multi-site operators?
Yes. Tell us the addresses and what each needs and we will quote them together.
Also near Horsley Cross
What else we do in Horsley Cross
Different parts, different methods
Multi-storey and shared buildings
Long ducts in larger buildings can mean several visits. Visits are planned around the building’s hours, out of hours where possible.
Attenuators and discharge
At the end of the duct is the discharge. Grease can collect there and stain the area around it, so it’s cleaned as far as safe access allows.
What happens on the day
The first job on site is protection: sheeting goes over floors and surfaces close to the work. After that, the system is made safe and the work begins. It takes from a few hours to more than one visit, depending on duct length and access, and the area is cleaned down before we leave. Visits to a village like Horsley Cross are booked in advance, at a time that suits whoever runs the site.
- We start by working out how the duct runs and where it can be opened.
- Set points along the runs are tested for grease.
- Through the access panels, thick grease is removed by hand first.
- The duct is degreased with the method that suits the grease, from degreasers to hot water or steam.
- We test again, take pictures and note any part that couldn’t be reached.
How to prepare
- Let us know when the site is closed or quiet
- Arrange a key holder or contact on site
- Make sure equipment near the work can be switched off and left to cool
Get a fixed quote
Quotes are quick. Call or email with a few details and you’ll normally have a fixed price within one working day. Where a survey is needed, we arrange a time that suits the site.
Related advice
What affects the cost of ductwork cleaning
Your quote is based on your site. We consider:
- Whether it’s a one-off visit or part of a schedule
- How big the system is
- Site requirements such as sign-in and permits
- How many systems or sites are involved
What you pay depends on how big the system is, what state it’s in and how easy it is to reach. You get a fixed price before we start, so there are no surprises.
What we need to know
When you call or email, it’s useful to have:
- The times we could work without disrupting the site
- Where the plant sits or the system leaves the building, such as a roof or outside wall
- Any access panels or hatches you can see
- The postcode and the type of business
Want a quote for ductwork cleaning? Please give us a ring on 0345 646 2711, or email photos with a few details about the site. We will explain what we’d do and send a fixed quote before you commit to anything.
Multi-site and managed buildings
Records are where multi-site compliance often slips. Each visit produces a dated report with pictures, ready to show insurers, fire officers or EHOs.
Landlords, managing agents and facilities managers book us, not only the businesses that use the systems. Shared systems, like a riser serving several units, need a clear agreement on who books the work, and we can quote for the whole system.
What staff can safely do
Some jobs should never be done in-house: entering ducts, working on fans, testing dampers and taking grease readings need training, the right equipment and safe access. Leave those to us.
Keep a record of what your team does. A dated log of in-house cleaning and checks shows an inspector that the system is looked after between visits, next to our reports.
What happens if it’s left?
BESA guidance says grease shouldn’t exceed a mean of 200 microns between cleans. Anywhere that reaches 500 microns or more needs immediate spot cleaning. Putting off the clean only pushes readings higher. Equipment tucked in a roof space or outbuilding near Horsley Cross rarely gets looked at unless someone books it.
The price reflects the work, not guesswork. That is why we survey first, from pictures or on site, and why the quote is fixed before any work starts.
What you get with us
- Member of BESCA Vent Hygiene Elite, cleaning to BESA TR19® Grease
- Evenings, overnight and weekends, plus 24/7 emergency callout
- CHAS, SafeContractor and ISO 9001
- Photo reports with every job
See our cost guide and how to check a contractor.
Keeping the system healthy
Here’s the after-treatment advice, in brief:
- Leave a way through to the access panels
- Book the next clean before the recommended date
- Store the certificate with the fire risk assessment
- Run the extract fan throughout service
Keep the certificate and report with the fire risk assessment. An insurer, fire officer or EHO may ask to see it, and the pictures make the duct’s condition easy to see.
Grease that never reaches the duct never needs cleaning out of it. Keep the filters clean, well fitted and in place whenever you cook.